Operation Manual

12 PowerScan

PD7100 Corded

Keyboard Standard Default Settings (Keyboard AT) —

Coun-

try Mode = U.S., Caps Lock= OFF, Numlock Key =Unchanged, Send

Control Characters = Disabled, Wedge Quiet Interval = 100ms, No

Wedge Intercode Delay.

Resetting the Standard Product Defaults

If programming settings for your reader are in an unknown condition,

factory settings can be restored by scanning the “Factory Default Set-

tings” barcode below. A listing of factory default settings is available in

the PRG. Settings can vary, depending upon the interface type.

Symbologies

Symbologies are factory enabled or disabled in the reader as follows:

Enabled Symbologies

• UPC-A, UPC-E, EAN 13, EAN 8 — without add-ons, Check

Character Transmission enabled, no Expansion, Minimum Reads

= 1 (except In-Store Minumum Reads = 2), System Number

Transmission = enabled, 2D Components = disabled, EAN 8

Guard Insertion/Substitution Options = disabled (except EAN 8

Guard Substitution), Stitching = disabled.

• Code 39 — Check Character Calculation/Transmission enabled,

Start/Stop Character disabled, Full ASCII disabled, Quiet Zones =

auto, Minimum Reads = 1, Decoding Level and Aggressiveness =

3, Variable Length Control, Length One = 2, Length Two = 50,

Interdigit Ratio = 4, Character Correlation = Disabled, Stitching is

enabled.

• Code 128 — No Expansion, Check Character Transmission

enabled, SubCode Change not transmitted, Quiet Zones = Auto,

Minimum Reads = 1, Decoding Levels and Aggressiveness = 3,

Factory Default Settings