Operation Manual

Enter/Exit Programming Mode

218

PowerScan™ PD9530/PBT9500/PM9500

Source Radio Address Delimiter Character

This option specifies the delimiter character to be placed between the label

data and radio address when address stamping is enabled.

$CBTAD

Set Source Radio Address Delimiter Character

To configure this feature, scan the ENTER/EXIT PRO-

GRAMMING MODE bar code above, then the bar code at

left foll

owed by the digits from the Alphanumeric charac-

ters in

Appendix D, Keypad

representing your

desired character(s). End by scanning the ENTER/EXIT bar

code agai

Make a mistake? Scan the CANCEL bar code to abort

and not save the entry string. You can then start

again at the beginning.

CANCEL

DEFAULT

00 = No Delimiter Character

This feature only applies if

"Source Radio Address Transmis-

sion"

on page 217 is enabled.