Specifications

POWERSCAN
™
D8330/M8300/M8300-DK
34
5.
Read the BC-8060 restore default code:
Restore BC-8060 Default
Ì$+RX0$-qÎ
6.
Read the desired Enable Network code.
Enable RS-485 Master
Ì$+RZ2$-ÇÎ
Enable R
S-485 Slave
Ì$+RZ1$-~Î
END of procedure.
For Host Master Network Layouts (see par. 3.2), The network configuration
parameters can be changed through STAR-Link™ software running on the PC.
Star-Link™ software can be downloaded for free from the web
site: www.datalogic.com.
For BC-8060 Master Network Layouts (see par. 3.2), The network configuration
parameters can be changed either through the Datalogic Aladdin™ configuration
software running on the PC or by reading the barcode selections in the Network
section of this manual starting on page 64. If using configuration barcodes, it
is advised to completely configure the cradles before reconfiguring the
PowerScan
™
M8300 reader (see below).
After completing the BC-8060 cradle configuration and
connections in the network, you must reconfigure
the PowerScan
™
M8300 reader using the STAR-System™
procedure in par. 4.6.
NOTE