Specifications

Enter Configuration

Exit and Save Configuration

Ì$+;Î

16-KEY DK MODEL PARAMETERS

Ì$-?Î

157

REPEAT TIMEOUT

Repeat Timeout allows the user to program an optional intercode delay (in msec.) between two

codes in a set of codes to be transmitted from scanner to host via Radio interface, when the

scanner is in quantity mode.

NOTE: Qty/Code Send Mode must be set to option 2 (code in CODE field is sent out for a

QTY number of times). See Qty/Code Send Mode on the previous page).

The number of codes depends on the unit inserted via keypad by the user, to cope with different

use cases. A minimum delay of 100 ms will be always present, the delay can be adjusted in

10ms increments.

Disable

set Repeat Timeout

 Read the above code.

 Sel

ect the length of the delay you want to set by scanning two barcodes (01 – 99) from the

Hex Numeric table in the back of this manual.

Example

: To pr

ogram Repeat Timeout = 60ms

set Repeat Timeout Value Time (ms)

Read +

60ms

