Instruction manual

POWERSCAN® D8530 FAMILY
11
DEFAULT CONFIGURATION
RS-232 Standard DEFAULT SETTINGS
115200 baud, no parity, 8 data bits, 1 stop bit, no handshake, no protocol, FIFO
enabled, intercharacter delay = 0, intercode delay = 0, serial trigger lock disabled, serial
trigger lock disable character = NUL, serial trigger lock enable character = NUL, RX
Timeout = 10 sec
USB COM Emulation DEFAULT SETTINGS
no handshake, no protocol, FIFO enabled, intercharacter delay = 0, intercode
delay = 0
USB Keyboard Emulation DEFAULT SETTINGS
USA keyboard*, intercharacter delay = 0, intercode delay = 0, FIFO enabled,
keyboard speed = normal
WEDGE Communication DEFAULT SETTINGS
USA keyboard*, CapsLock OFF, CapsLock Auto-Recognition ON, NumLock OFF,
intercharacter delay = 0, intercode delay = 0
DATA FORMAT – Symbology Independent Parameters
custom code identifier disabled, code identifier disabled, code length disabled
Default headers and terminators*:
- RS-232: no header, terminator = CR-LF
- USB BULK: no header, terminator = CR-LF
- USB COM: no header, terminator = CR-LF
- USB Generic HID: no header, terminator = CR-LF
- Wedge: no header, terminator = ENTER
- USB Keyboard: no header, terminator = ENTER
DATA FORMAT – Symbology Dependent Parameters
symbology specific format = select all, no headers, no terminators, symbology
character substitution disabled, symbology character deletion disabled
DATA FORMAT – Concatenation
Concatenation disabled, 2 EAN/UPC codes concatenated, Set First Concatenated
Code Length 000 = any length, Set Second Concatenated Code Length 000 = any
length, Set Third Concatenated Code Length 000 = any length, Set Fourth
Concatenated Code Length 000 = any length, Concatenation with Intercode Delay
disabled, Concatenation Timeout 10 seconds, Concatenation Failure
Transmission = Tx codes causing failure, Transmission after Timeout = No code
transmission, Concatenation Result Code ID = No code Identifier
ADVANCED FORMATTING PARAMETERS
format disabled
CAMERA CONTROL
exposure mode = automatic, based on entire image
POWER SAVE
Illumination power = ON
* The default values of these parameters are set when reading the interface
selection.