Instructions

References
306 PowerScan™ PD9530/PBT9500/PM9500
PM9500-Only Features
Changing System Speed in Normal Mode
1. Link the PM9500 with a BC9xxx Base.
2. With the PM9500, read a Compatible Mode programming
label on
page 240 to set low, intermediate, or high speed.
3. Place the PM9500 into the BC9xxx.
The Reader and Base will now be linked at
the new programmed speed.
This feature can also be programmed us
ing Datalogic Aladdin.
1. On the BC9xxx Base, change the Compatible m
ode parameter to low,
intermediate, or high speed through Aladdin.
2. Place an unlinked PM9500 onto the BC9xxx base.
The Reader and base will link with the new
programmed speed.
Bluetooth-Only Features
Bluetooth Pin Code
This option specifies the 4-character or 16-character pin code to be used
for authentication of the Bluetooth link. To set the pin code:
1. Sc
an the ENTER/EXIT PROGRAMMING MODE bar code to enter Program-
ming Mode, then enable "Bluetooth Security Mode" on pa
ge 226.
2. S
pecify the desired pin code length (4 or 16) by scanning the appropri-
ate bar code in "Select PIN Code Length" on
page 226.
3. Determine the desired characters. For example, D254 or
ST
OR12345678135M.
4. Convert the characters to hexadecimal using the ASCII Chart on
the
inside back cover of this manual.
5. Go to page 226 and Scan the bar code: SET 4 CHAR PIN CODE or SET
16-CHAR PIN CODE.
6. Scan the appropriate alphanumeric characters from the keypad in
Appendix D, Keypad, representing the hexadecimal entries determined
in the steps above. You will hear a two-beep indication after the last
c
haracter.
If you make a mistake before the last character, scan the CANCEL bar code
to abort and not save the entry string. You can then start again at the
beginning.