Instructions

Enter/Exit Programming Mode
270 PowerScan™ PD9530/PBT9500/PM9500
Set Key Sequence ID
Sets the identifier for keyboard composed strings.
$CPWEC
Set keys sequence ID
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code at
left f
ollowed by 6 digits from
Appendix D, Keypad .
The ID characters must be represented by their hexadeci-
mal ASCII code; if the first 2 digits are 0, this feature is dis-
abled. End by scanning the ENTER/EXIT ba
r code again.
Set Key Sequence Header
Sets the header for keyboard composed strings.
$CPWE1
Set key sequence header
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code at
le
ft followed by 32 digits from the Alphanumeric char-
acters in
Appendix D, Keypad . The digits must be
the hexadecimal ASCII representation of the desired
char
acters.
If less than the expected string of 16 characters are
se
lected, scan the ENTER/EXIT bar code to terminate
the string.
If the first 2 digits are 0, the feature is di
sabled. End by
scanning the ENTER/EXIT bar code again.
Set Key Sequence Terminator
Sets the terminator for keyboard composed strings.
$CPWE2
Set key sequence terminator
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code at
le
ft followed by 32 digits from the Alphanumeric char-
acters in
Appendix D, Keypad . The digits must be
the hexadecimal ASCII representation of the desired
char
acters.
If less than the expected string of 16 characters are
se
lected, scan the ENTER/EXIT bar code to terminate
the string.
If the first 2 digits are 0, the feature is di
sabled. End by
scanning the ENTER/EXIT bar code again.