Instructions

Enter/Exit Programming Mode
262 PowerScan™ PD9530/PBT9500/PM9500
Quantity/Code Send Mode
This feature defines the rules that will be used to send a QTY/CODE pair:
0. Code is transmitted with QTY fiel
d (and its predefined format) preced-
ing CODE field (and its predefined format)
1. Code is transmitted with CODE fie
ld (and its predefined format) preced-
ing QTY field (and its pre
defined format)
2. Code in CODE field is
sent out for the number of times defined in the
QTY field
$CPWEH00\r
Qty precedes Code
DEFAULT
$CPWEH01\r
Code precedes Qty
$CPWEH02\r
Code transmitted Qty times
Quantity/Code Separator
This feature allows the insertion of a separator between Qty/Code pairs.
DEFAULT
$CPWQP00\r
No separator
$CPWQP
Set Qty/Code string separator
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the barcode at
le
ft. Next scan 1 digit from
Appendix D, Keypad (in
the range 1-8) representing the number of characters to
be us
ed as separator.
Finally, define the separator string by reading the
desired characters from the ASCII table at the back of
this manual, expressed in he
xadecimal form. End by
scanning the ENTER/EXIT bar code again.