Instructions

Enter/Exit Programming Mode
Product Reference Guide 251
Arrow Keys Mode (4-key models only)
Configure the Arrow Keys functionality type. Two options are available:
Function Keys Action Select mode: When in this mode, arrow keys are used to
select one of the 3 possible actions associated to the Function Keys. To
associate actions to the Function keys, see "Co
nfigure Actions for Function
keys" on page 253.
String Association Mode: When in this mode, each one of the arrow keys can
be programmed to display and transmit a pre-defined string (see
"Arrow Up
String (4-key models only)" on page 251
and "Arrow Down String (4-key
models only)" on page 252
).
$CDIAC00\r
Function Keys Action Select mode
DEFAULT
$CDIAC01\r
String Association Mode
Arrow Up String (4-key models only)
Associate a pre-defined string to the Arrow Up key
$CDAUS
Set string for Arrow Up Key
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code at
left.
Define the label string by further scanning 32
digits from the Alphanumeric characters in
Appen-
dix D, Keypad
.
The digits must be the hexadecimal ASCII representa-
tion of the desired characters;
if less than the expected
string of 16 characters are selected, scan the ENTER/
EXIT bar code to terminate the string.
End by scanning the ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort
and not save the
entry string. You can then start again
at the beginning.
~
CANCEL