User's Manual

Table Of Contents
WARNING: If the device or the battery is dropped, especially on a hard surface, you
should take it to the nearest Authorised Repair Centre for inspection before continuing
to use it.
If your device stops working for any reason, do not use its battery on other electronic
devices without a prior check and approval by an Authorised Repair Centre.
Do not remove or damage the battery pack’s label.
Do not use the battery pack if it is damaged in any part.
Battery pack usage by children should be supervised.
Collect and recycle waste batteries separately from the device in compliance with
European Directive 2006/66/EC, 2011/65, 2002/96/EC and subsequent modifications,
with US and China regulatory laws and regulations about the environment.
DIRECTIVES RELATIVES À LA SÉCURITÉ DES BATTERIES
AVERTISSEMENT: Installation, chargement et / ou toute autre action doit être
effectuée par du personnel autorisé et après ce manuel.
La batterie peut devenir chaude, exploser, s’enflammer et / ou causer des blessures
graves en cas d’exposition à des conditions abusives. Si la batterie est remplacée par
un type incorrect, il y a risque d’explosion.
Ne placez pas la batterie dans ou près d’un feu ou autre source de chaleur; ne placez
pas la batterie dans la lumière directe du soleil, ou utiliser ou stocker la batterie à
l’intérieur zones non ventilées par temps chaud; ne placez pas le batterie dans les
fours à micro-ondes, dans les sécheuses, dans récipients à
haute pression, sur des surfaces de cuisson à induction ou appareils similaires. Si
vous le faites, la batterie générer de la chaleur, exploser ou s’enflammer. Utilisation de
la batterie de cette manière peut également entraîner une perte de
performance et une espérance de vie raccourcie.
WIRELESS AND RADIO FREQUENCIES WARNINGS
WARNING: Use only the supplied or an approved replacement antenna. Unauthorized
antennas, modifications or attachments could damage the product and may violate
laws and regulations.
Most modern electronic equipment is shielded from RF signals. However, certain
electronic equipment may not be shielded against the RF signals generated by
Memor K.
Datalogic recommends persons with pacemakers or other medical devices to follow
the same recommendations provided by Health Industry Manufacturers Associations
for mobile phones.
Persons with pacemakers:
Should ALWAYS keep this device more than twenty five (25) cm from their
pacemaker and/or any other medical device;
Should not carry this device in a breast pocket;
Should keep the device at the opposite side of the pacemaker and/or any other
medical device;
Should turn this device OFF or move it immediately AWAY if there is any reason
to suspect that interference is taking place.
Should ALWAYS read pacemaker or any other medical device guides or should
consult the manufacturer of the medical device to determine if it is adequately
shielded from external RF energy.
In case of doubt concerning the use of wireless devices with an implanted medical
device, contact your doctor.
Turn this device OFF in health care facilities when any regulations posted in these
areas instruct you to do so. Hospitals or health care facilities may use equipment
that could be sensitive to external RF energy.
RF signals may affect improperly installed or inadequately shielded electronic
systems in motor vehicles. Check with the manufacturer or its representative
regarding your vehicle. You should also consult the manufacturer of any equipment
that has been added to your vehicle.
An air bag inflates with great force. DO NOT place objects, including either installed
or portable wireless equipment, in the area over the air bag or in the air bag
deployment area. If a vehicle’s wireless equipment is improperly installed and the
air bag inflates, serious injury could result.
Turn off the device when in any area with a potentially explosive atmosphere.
Observe restrictions and follow closely any laws, regulations, warnings and best
practices on the use of radio equipment near fuel storage areas or fuel distribution
areas, chemical plants or where any operation involves use of explosive materials.
WARNING: Do not store or carry flammable liquids, explosive gases or materials
with the device or its parts or accessories.
Areas with a potentially explosive atmosphere are oen, but not always, clearly
marked or shown.
Sparks in such areas could cause an explosion or fire, resulting in injury or even
death.
LED CLASS
LED illuminator integrated in the imager engine is classified as “EXEMPT RISK GROUP” according
to IEC62471.
FCC COMPLIANCE
Notice:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that may cause unde-
sired operation.
FCC ID: U4GMEMKUS
Note:
Changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
Note:
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCCRules.
These limits are designed to provide reasonable protection against harmful interference in a resi-
dential installation. This equipment generates uses and can radiate radio frequency energy and,
if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a parti-
cular installation. If this equipment does cause harmful interference to radio or television recep-
tion, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
y Reorient or relocate the receiving antenna.
y Increase the separation between the equipment and receiver.
y Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
y Consult the dealer or an experienced radio/TV technician for help.
These limits are designed to provide reasonable protection against harmful interference in a resi-
dential installation. This equipment generates uses and can radiate radio frequency energy and,
if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be deter-
mined by turning the equipment off and on, the user is encouraged to try to correct the interfe-
rence by one or more of the following measures:
y Reorient or relocate the receiving antenna.
y Increase the separation between the equipment and receiver.
y Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
y Consult the dealer or an experienced radio/TV technician for help.
Body-worn Operation
This device was tested for typical body-worn operations. To comply With RF exposure require-
ments, a minimum separation distance of 1.0cm must be maintained between the user’s body
and the handset, including the antenna. Third-party belt-clips, holsters, and similar including the
antenna. Third-party belt-clips, holsters, and similar accessories used by this device should not
contain any metallic com-ponents. Body-worn accessories that do not meet these requirements
may not comply with RF exposure requirements and should be avoided.
Specific Absorption Rate (SAR) information:
This wireless phone meets the government’s requirements for exposure to radio waves. The
guidelines are based on standards that were developed by independent scientific organizations
through periodic and thorough evaluation of scientific studies. The standards include a substantial
safety margin designed to assure the safety of all persons regardless of age or health.
FCC RF Exposure Information and Statement:
The SAR limit of USA (FCC) is 1.6 W/kg averaged over one gram of tissue. Device types:
U4GMEMKUS has also been tested against this SAR limit. The highest SAR value reported under
this standard during product certification for use at the ear is 0.870W/kg and when properly worn
on the body is 0. 975W/kg, warn on limb is 0.988W/kg . This device was tested for typical body-worn
operations
with
the back of the handset kept 1cm from the body. To maintain compliance with
FCC RF exposure
requirements, use accessories that
maintain a 1cm separation distance
between the user’s body and the back of the handset.
The
use of belt clips, holst-ers and similar accessories should not contain metallic components in its
assembly. The use of accessories that do not satisfy these requirements may not comply with FCC
RF exposure requirements, and should be avoided.
The device for operation in the band 5150-5250 MHz is only for indoor use to reduce the potential
for harmful interference to cochannel mobile satellite systems.
ISED COMPLIANCE
Notice:
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause unde-
sired operation.
Caution:
(i) the device for operation in the band 5150-5250 MHz is only for indoor use to reduce the poten-
tial for harmful interference to cochannel mobile satellite systems;
(ii) high-power radars are allocated as primary users (i.e. priority users) of the bands 5250-
5350MHz and 5650-5850 MHz and that these radars could cause interference and/or damage to
LE-LAN devices.
The highest SAR value reported under this standard during product certification for use at the ear
is 0.870W/kg and when properly worn on the body is 0.975W/kg, warn on limb is 0.988 W/kg.
ISED Radiation Exposure Statement
This device is compliant with SAR for general population/uncontrolled exposure limits in RSS-
102 and has been tested in accordance with the measurement methods and procedures specified
in IEEE 1528 and IEC 62209. This equipment should be installed and operated with a minimum
distance of 0.39 in(10mm) between the radiator and your body. This device and its antennas must
not be co-located or operated in conjunction with and other antenna or transmitter.
CONFORMITÉ ISDE
Remarquer:
Cet appareil est conforme aux normes RSS exemptes de licence d’Industrie Canada.
Son fonctionnement est soumis aux deux conditions suivantes:
(1) cet appareil ne doit pas provoquer d’interférences nuisibles, et
(2) cet appareil doit accepter toute interférence reçue, y compris les interférences pouvant
entraîner un fonctionnement indésirable.
Mise en garde:
(i) le dispositif destiné à fonctionner dans la bande 5150-5250 MHz est uniquement destiné à une
utilisation en intérieur afin de réduire le potentiel d’interférences nuisibles aux systèmes mobiles
par satellite à canaux multiples;
(ii) les radars haute puissance sont attribués en tant qu’utilisateurs principaux (c’est-à-dire les
utilisateurs prioritaires) des bandes 5250-5350 MHz et 5650-5850 MHz et que ces radars pourra-
ient causer des interférences et / ou endommager les dispositifs LE-LAN.
La valeur SAR la plus élevée déclarée en vertu de cette norme lors de la certification du produit
pour une utilisation à l’oreille est de 0.870 W / kg et lorsqu’elle est correctement portée sur le
corps est de 0.975 W / kg, avertir sur le membre est de 0,988 W / kg
Déclaration sur l’exposition aux radiations d’ISDE
Cet appareil est conforme aux limites d'exposition DAS incontrôlée pour la population générale
de la norme CNR-102 Innovation. Scinces et Développement économique Canada et a été testé en
conformité avec les méthodes de mesure de procédures spécifiées dans IEEE 1528 et IEC 62209.
Cet appareil doit être installé et utilisé avec une distance minimale de 10mm entre I'émetteur et
votre corps. Cet appareil et sa ou ses antennes ne doivent pas être co-localisés ou fonctionner en
conjonction avec tout autre antenne ou transmetteur.