Instruction manual

INTRODUCTION

green

yellow

red

green

yellow

red

green

yellow

red



Release button

to enter Setup Mode



Release button

to enter Learn Mode

 (cycle)

Release button

to Exit

Test Mode (Function 1)

Once entered, the Bar Graph on the five LEDs is activated and if the imager starts reading

codes the Bar-Graph shows the Good Read Rate. In case of a NO READ condition, only the

Status

LED is on and blinks.

The Bar Graph has the following meaning:

≥ 95%

≥ 75%

≥ 60%

≥ 40%

≥ 20%

To exit the Test Mode, press the X-PRESS™ push button once.

NOTE

By default, the Test exits automatically after three minutes.

Aim/Locate (Function 2)

This function causes the blue ring to turn on. Since the blue ring is centered on the FOV it

can be used to position the imager on the code. The Aim LED blinks to indicate this state.

To exit the Aim/Locate Mode, press the X-PRESS™ push button once. The blue ring turns

off.