Operation Manual

Laser and Product Safety
Product Reference Guide 1-13
Safety precautions to be taken:
Canadian Notice
This equipment does not exceed the Class B limits for radio noise emis-
sions as described in the Radio Interference Regulations of the Canadian
Department of Communications.
CAUTION
No adjustments or alteration of the scanner or scanner/scale
housing are to be attempted by the user.
The failure of the facet wheel motor while the unit is continuing
to emit a laser beam causes the emission levels to exceed
those for inherently safe operation. The unit has safeguards to
prevent this occurrence. If, however, a stationary laser beam is
ever emitted, the failing unit should be disconnected from its
power supply until repaired by a qualified technician.
WARNING
This equipment has been tested and found to comply with the
limits for a Class B digital device pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installa-
tion. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interfer-
ence will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television recep-
tion, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interfer-
ence by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
• Consult the dealer or an experienced radio or television
technician for help.