Operation Manual

Data Editing

Magellan

3300HSi

Global Prefix/Suffix

START / END

PROGRAMMING bar codes

Sets up to 20 characters each from the set of ASCII characters or any hex value from 00 to FF. To configure this feature, scan the

“START/END” bar code above to place the unit in Programming Mode, then the “Set Prefix” or “Set Suffix,” followed by the digits from

the Alphanumeric table in

Appendix C, Alpha-Numeric Pad representing your desired character(s). Reference the section, Global

Prefix/Suffix on page 152

, for more information on setting this feature. Exit programming mode by scanning the “START/END” bar

code again (scan “START/END” twice if less than 20 characters have been selected).

DEFAULT SETTING PREFIX: 00 (None)

DEFAULT SETTING SUFFIX: 0D (CR)

Set Prefix

Set Suffix