Instruction manual

M-Series Processor and Camera Guide MX80 DVI-I Video Connector
5-3 Datalogic Automation, Inc.
MX80 DVI-I Video Connector
The MX80 processor requires a monitor and keyboard when it first starts, and to configure the system. A VGA cable with
the appropriate adapter can be used on this connector (10 meters maximum).
M1xx Camera
The terminal block and cable for connecting M-Series M1xx cameras are listed in the table below. For cable wire color
codes and connection diagrams, see “M1xx Camera Connection” on page 3-8. The last two digits of the part number indi-
cate the cable length in meters.
M2xx and M3xx Cameras
The terminal block and cable for connecting M-Series M2xx and M3xxcameras are listed in the table below. For cable
wire color codes and connection diagrams, see “M2xx and M3xx Camera Connection” on page 3-12. The last two digits
of the part number indicate the cable length in meters.
M5xx Camera
The terminal block and cable for connecting M-Series M5xxcameras are listed in the table below. For cable wire color
codes and connection diagrams, see “M5xx Camera Connection” on page 3-16.
NOTE: Do NOT use the M2xx/M3xx terminal block (661-0400) to connect this camera. It will not provide the correct
signal levels.
The last two digits of the part number indicate the cable length in meters.
Connector Type Part Number
Terminal Block 661-0399
Camera Cable - DB9 to 6-pin Hirose Male (for use
with above terminal block)
606-0674-xx
Connector Type Part Number
Terminal Block 661-0400
Camera Cable - HD-15 to 12-pin Hirose Male (for use with above terminal block) 606-0673-xx
Connector Type Part Number
Terminal Block 661-0401
I/O Cable - HD-15 to 12-pin Hirose Male (for use with above terminal block) 606-0673-xx
Power Cable - DB9 to 6 pin Hirose Male (for use with above terminal block) 606-0674-xx