Instruction manual

Safety Precautions M-Series Processor and Camera Guide
Datalogic Automation, Inc. 1-2
• MX40 M-Series Processor with 3 cameras: 661-0396-M40-3
• MX40 M-Series Processor with 4 cameras: 661-0396-M40-4
• MX80 M-Series Processor with 1 camera: 661-0404-MX80-1
• MX80 M-Series Processor with 2 cameras: 661-0404-MX80-2
• MX80 M-Series Processor with 3 cameras: 661-0404-MX80-3
• MX80 M-Series Processor with 4 cameras: 661-0404-MX80-4
• For details about cameras, see “M-Series Cameras” on page 3-1
• For details about M-Series cables, see “Cables” on page 5-1
To configure a camera, connect a monitor and keyboard to the appropriate M-Series Processor port, then connect the cam-
era’s Ethernet connector to the appropriate M-Series camera port. See M-Series Cameras on page 3-1 for details.
An optional power supply is available for M-Series Processors. If you provide your own, it must supply 10 to 30VDC
with a safe operating ambient temperature range of 0° to +55° C (+32° to +131° F).
This equipment is to be powered by a Listed power supply for the U.S. and Canada, or a power supply that meets the
requirements for use where either IEC 60950 or EN60950 is applicable.
Safety Precautions
Warning: There are no user-serviceable parts inside the hardware. To avoid electrical shock, never open the case.
Opening the case or removing the tamper-proof sticker will void the product warranty.
Attention: Il n'ya pas de pièces réparables par l'utilisateur à l'intérieur du matériel. Pour éviter un choc électrique,
n'ouvrez jamais le boîtier. L'ouverture du boîtier ou de retirer l'étiquette inviolable annulera la garantie du produit.
Warning: See Mounting Warning on page 2-3.
1. Read all of the following instructions before setting up your system. Save this document for later use.
2. Follow all warnings and instructions in this manual and in other user guides shipped with your hardware compo-
nents.
3. To avoid damage to the vision system and its components, never plug in or unplug a cable when the power is on.
Always turn off the power supply before you make cable changes.
4. Never use the system if a power cable has been damaged. Do not allow anything to rest on a power cable and keep
them away from traffic.
5. The air inlets and exhausts on the top and sides of the unit are for ventilation. Do not block or cover these openings
or insert anything into these openings. Metal screen filters may be installed in the fan exhausts.
6. Do not expose the vision system to moisture, rain, or snow, and do not use it near water. If a component gets wet
unplug it.