Instruction manual

ManualsBrandsDatalogic ManualsComputer equipmentM-Series

Connecting the Camera M-Series Processor and Camera Guide

Datalogic Automation, Inc. 3-8

Connecting the Camera

WARNING: Never wire M1xx Camera Strobe Outputs in parallel with M1xx, M2xx, or M3xx Camera Strobe Outputs.

This will damage the cameras.

M1xx Camera Connection

To connect M1xx camera power, trigger signals, and strobe outputs, use cable 606-0674-xx (6

pin Hirose Male to DB9) with terminal block 661-0399.

NOTE 1: If Camera Trigger In requires a sinking signal, set the Software Trigger Event to Rising Edge. If it requires a

sourcing signal, set the Software Trigger Event to Falling Edge.

NOTE 2: If Strobe Trigger Output requires a sinking signal, set the Strobe Trigger Output to Falling Edge. If it requires a

sourcing signal, set the Strobe Trigger Output to Rising Edge.

NOTE 3: Disconnecting the camera will turn on some strobe lights.

Terminal Name Signal Notes

Optional Camera

Power +12VDC

Camera Power Do NOT apply power to this terminal if

using Power Over Ethernet (PoE)

+12 VDC (+-10%) @ 250 mA Max

Maximum: +13.2 VDC

Minimum: +11.3 VDC

Optional Camera

Power Ground

Camera Power Ground Required when NOT using Power

Over Ethernet (PoE)

I/O Ground I/O Ground

Trigger In** Camera Trigger In 0 to +24 VDC recommended

Maximum +30 VDC

As sinking input

Off: 0 to +1.4 VDC

On: +2.2 to +24 VDC; 5 to 15 ma

As sourcing input (see Trigger Pullup +VCC)

Off: +2.2 to +24 VDC; 5 to 15 ma

On: 0 to +1.4 VDC

Trigger Pullup

+VCC**

Trigger In Pullup - use if

Trigger In needs sourc-

ing (see Note 1 below)

+24 VDC recommended

Maximum +30 VDC

(**Block contains 1.6k Ohm 1W resistor between Trigger In

and Trigger Pullup +VCC)

Strobe Output

Pullup +VCC*

Strobe Supply Voltage -

use if Strobe Trigger

Output needs sourcing

(see Note 2 below)

Based on Strobe requirement (optional)

Max: +30 VDC; 50 ma

(*Block contains 1.6k Ohm 1W resistor between Strobe Trig-

ger Output and Strobe Output Pullup +VCC)

Strobe Trigger

Output*

Trigger Out to Strobe

(see Note 3 below)

DO NOT APPLY ANY VOLTAGE DIRECTLY TO THIS OUT-

PUT. DO NOT WIRE OUTPUTS IN PARALLEL.