Instruction manual

M-Series Processor and Camera Guide Mounting the Camera

3-7 Datalogic Automation, Inc.

Mounting the Camera

This section provides instructions for mounting our cameras. For information about third-party cameras, consult the man-

ufacturer’s documentation for those cameras.

To mount an M-Series camera (except M5xx)

1. With the mounting block held tightly against the camera body, insert two mounting bolts through the mounting

bolt holes (see diagram).

2. Turn the mounting bolt clockwise to tighten the block and secure it to the camera.

3. Use appropriately sized fasteners in the pre-threaded holes in the bottom of the mounting bracket to secure the

mounting block to a rigid surface for proper stability and heat transfer. (See “Camera Dimensions” on page 3-3.)

To mount an M5xx camera

1. With the camera body held tightly against the desired mounting surface, insert two mounting bolts through the

mounting surface and into the mounting bolt holes (see diagram).

M1xx Mounting Block

(381-1355)

Camera Front

Mounting Bolts M3 (2 ea.)

M2xx and M3xx Mounting Block

(381-1354)

Mounting Bolts M3 (2 ea.)

Mounting Bolt holes M4 (2 ea.)

Bottom View