Instruction manual

3-1 Datalogic Automation, Inc..
CHAPTER 3
M-Series Cameras
Introduction
This section describes digital cameras provided by Datalogic Automation, Inc. and other third-party manufacturers. Our
cameras can be used only with our M-Series Processors. The M-Series processors and Impact software will also support
the third-party cameras listed later in this chapter.
Datalogic Automation, Inc. does not support the use of these cameras in any manner other than described herein.
M-Series cameras acquire an image when a signal is present on the trigger input of the camera trigger/power cable, then
digitize images at the camera source and transmit them directly to the processor over the Ethernet cable. These cameras
provide 8-bit resolution using internal 12-bit A/D converters and some have progressive scan shutter exposure (allowing
individual pixel readings). Third-party cameras may have different specifications. All cameras are capable of Gigabit
transmission rates.
M-Series cameras have a hard-coat finish case that helps eliminate ground loops. All camera settings (shutter, strobe, par-
tial scan, etc.) are configured using Impact software and are maintained in the M-Series processors’ memory so there are
no physical switches on the cameras.
All camera settings must be configured using the Settings tab in the Vision Program Manager (VPM) or Settings program.
For more detailed information, refer to the Impact Reference Guide (843-0093).
Safety Precautions
Read all of the following instructions before setting up your camera. Save this document for later use.
• Follow all warnings and instructions in this manual and in other user guides shipped with your hardware components.
• Do not attempt to disassemble the camera. Do not remove screws or attachments. There are no user-serviceable parts
inside. Refer servicing to Datalogic Automation, Inc.
• All M-Series and third-party cameras connect to the M-Series Processors using a Cat5E Ethernet cable (606-0457-x).
Cat6 cable is required for distances greater than 25 meters. Using any other cable may cause intermittent data transmis-
sion. Cameras connect to power and triggering signals using a cable and terminal block. See “Connecting the Camera”
on page 3-8 for more details.
NOTE: We recommend that you do not use a switch or a router between the M-Series Processor and the camera.
• This camera is designed for indoor use. Do not expose it to moisture, including rain or snow, and avoid operating it in
wet areas. Should the camera become wet, turn off the power immediately. Moisture can damage the camera and create
danger of electric shock. Avoid using the camera when the humidity is above 90%.