Instruction manual

M-Series Processor and Camera Guide DIN Rail Mounting
2-5 Datalogic Automation, Inc.
DIN Rail Mount Kit Installation
NOTE: If the Processor uses a Compact Flash card, mount with the Processor front facing upward so the CF card
does not fall out due to vibration.
To mount the Processor using the DIN Rail Mount kit (see diagram):
1. To fasten the mounting bracket to the bracket holding plate, insert the bracket mounting screws from the
reverse side of the bracket holding plate.
Be sure to use the appropriate holes in the holding plate for the desired bracket orientation. The part of the
bracket that contains the butterfly clip should be on the bottom.
2. Fasten the bracket holding plate onto the bottom of the processor using the plate mounting screws.
3. Hook the bottom of the mounting bracket in the bottom flange of the DIN rail. The butterfly clips will offer some
resistance.
4. While exerting slight upward force, clip the top of the mounting bracket over the top flange of the DIN rail.
5. Verify that the bracket is clipped securely to the rail.
DIN Rail Mounting (Fan Down)
Processor front
Butterfly
Clip
Mounting Bracket
Bracket Holding Plate
Bracket Mounting
Screws (x2)
Plate
Mounting
Screws
(x4)
Bottom View
IMPORTANT: See Mounting Warning on page 2-3.
Processor front