Instruction manual

M-Series Processor and Camera Guide Preventive Maintenance
1-9 Datalogic Automation, Inc..
Preventive Maintenance
Warning: There are no user-serviceable parts inside the device. To avoid electrical shock, never open the case.
Opening the case or removing the tamper-proof sticker will void the product warranty.
Attention: Il n'ya pas de pièces réparables par l'utilisateur à l'intérieur du matériel. Pour éviter un choc électrique,
n'ouvrez jamais le boîtier. L'ouverture du boîtier ou de retirer l'étiquette inviolable annulera la garantie du produit.
This section contains tips to keep your system trouble-free and operating smoothly.
• Make sure there is at least 1.5 inches (38.1 mm) of clearance on the sides and top of the M-Series Processor.
• The M-Series Processor should be mounted securely in a vibration-free location.
• Keep the outside of the unit clean and free of oil and dust. You can clean the unit with a mild cleanser. Do not use an
abrasive cleaner and never immerse the unit in water.
• Periodic cleaning of the air inlets and exhausts is highly recommended.
• Verify that all cable connections are correct and tight. Secure the cables to prevent accidents or damage to the device
connectors.
• When you move the system, be careful that the movement does not loosen connections. After the system is moved, ver-
ify cable and power cord connections.
• Repair or replace frayed or damaged cables immediately.
• Do NOT attempt to clean the camera imager or imager cover. Do NOT spray the imager or imager cover with com-
pressed air as this may leave spots.
Before You Call
If you have a problem with your system, you can contact your distributor or call Datalogic Automation, Inc. Before call-
ing, however, review the preceding maintenance checklist to ensure you are not overlooking an obvious reason for your
problem.
When you call for support, be prepared to answer to the following questions:
• What are the model and serial numbers of the device you are using? The device model, serial, and part numbers are
located on the back of the processor.
• Have you added, replaced, or reconfigured your hardware recently? This includes any changes to the camera or
other components.
• What is the version number of Impact Software Suite you are running? To find it, look on the title bar of one of the
Impact Software components.
• Have you updated or replaced any software on your client computer lately?