Instruction manual

Basler Cameras (Older Terminal Blocks) M-Series Processor and Camera Guide

Datalogic Automation, Inc. 6-20

CAMERAS.

Camera power, trigger signal, and strobe trigger can be connected to the camera using one of two methods: a terminal

block and cable or an unterminated cable only. To use a terminal block (248-0141), you must also use the optional Hirose

12-pin to HD-15 camera cable (606-0673-xx). To connect the camera using an unterminated cable, use the optional

Hirose 12-pin to unterminated cable (part number 606-0671-xx).

NOTE 1: Pins 1 and 2 are tied together inside of the camera. Pins 8 and 9 are tied together inside of the camera. To avoid

a voltage drop when there are long wires between your power supply and the camera, we recommend that you provide

camera power VCC through separate wires between your power supply and pins 8 and 9 on the camera. We also recom-

mend that you provide camera power ground through separate wires between your power supply and pins 1and 2 on the

camera.

Terminal Color Signal Name Notes

Wht/Blu

Wht/Org

Camera Power Ground

See Note 1 below

3 Wht/Brn Camera Trigger In 0 to +24 VDC recommended

Off: 0 to + 1.4 VDC

On: +2.2 to + 12VDC; 5 to 15 ma

Maximum: +30 VDC

4 Brn/Wht DO NOT USE

5 Wht/Grn Camera Trigger Ground

6* Wht/Gry Strobe Trigger Out

7 Gry/Wht DO NOT USE

Blu/Wht

Org/Wht

Camera Power VCC

+12 VDC recommended @ 500 mA Max

Maximum: +13.2 VDC

See Note 1 below

10 Grn/Wht Strobe VCC Based on strobe requirement

Maximum: +30 VDC; 50 ma

11 Red/Blu DO NOT USE

12 Blu/Red DO NOT USE

13* None Strobe Output Ground (*Block contains 270 Ohm 2W resistor between

terminals 6 and 13)