Operation Manual
Table Of Contents
- CONTENTS
- REFERENCES
- GENERAL VIEW
- 1 INTRODUCTION
- 2 BATTERIES AND MAINTENANCE
- 3 CONNECTIONS
- 4 USE AND FUNCTIONING
- 4.1 STARTUP
- 4.3 DATA CAPTURE
- 4.4 DESCRIPTION OF THE KEYS
- 4.5 STATUS INDICATORS
- 4.6 SETTINGS
- 4.7 CONNECTING TO OTHER COMPUTERS
- 4.8 DATALOGIC FIRMWARE UTILITY
- 4.9 DATALOGIC CONFIGURATION UTILITY
- 4.10 RADIO POWER MANAGEMENT
- 4.11 DATALOGIC DESKTOP UTILITY
- 4.12 APPSELECTOR (APPLICATION SELECTOR)
- 4.13 LOCKED WEB BROWSER
- 4.14 AUTOSTART
- 5 TECHNICAL FEATURES
- 6 TEST CODES
- SAFETY REGULATIONS
- GLOSSARY
- INDEX
- DECLARATION OF CONFORMITY
BATTERIES AND MAINTENANCE
13
2
2 BATTERIES AND MAINTENANCE
Rechargeable backup batteries and battery packs are not initially
fully charged. Therefore the initial operation to perform is to charge
them. See below.
NOTE
Annual replacement of rechargeable battery pack avoids possible
risks or abnormalities and ensures maximum performance.
CAUTION
2.1 CHARGING THE BATTERY PACK
The battery pack autonomy varies according to many factors, such
as the frequency of barcode scanning, RF usage, battery life,
storage, environmental conditions, etc.
NOTE
The battery icon on the Taskbar indicates when the battery pack is low.
It is possible to recharge the battery pack by connecting the power supply directly to
the Lynx.
Alternatively, it is also possible to recharge the battery pack by using a Single Cradle
or the Lynx Multi Battery Charger.