Operation Manual
Table Of Contents
- CONTENTS
- REFERENCES
- GENERAL VIEW
- 1 INTRODUCTION
- 2 BATTERIES AND MAINTENANCE
- 3 CONNECTIONS
- 4 USE AND FUNCTIONING
- 4.1 STARTUP
- 4.3 DATA CAPTURE
- 4.4 DESCRIPTION OF THE KEYS
- 4.5 STATUS INDICATORS
- 4.6 SETTINGS
- 4.7 CONNECTING TO OTHER COMPUTERS
- 4.8 DATALOGIC FIRMWARE UTILITY
- 4.9 DATALOGIC CONFIGURATION UTILITY
- 4.10 RADIO POWER MANAGEMENT
- 4.11 DATALOGIC DESKTOP UTILITY
- 4.12 APPSELECTOR (APPLICATION SELECTOR)
- 4.13 LOCKED WEB BROWSER
- 4.14 AUTOSTART
- 5 TECHNICAL FEATURES
- 6 TEST CODES
- SAFETY REGULATIONS
- GLOSSARY
- INDEX
- DECLARATION OF CONFORMITY
6
140
RADIO COMPLIANCE
In radio systems configured with PDAs and access points, the frequencies to be used
must be allowed by the spectrum authorities of the specific country in which the
installation takes place. Be absolutely sure that the system frequencies are correctly
set to be compliant with the spectrum requirements of the country.
The Radio modules used in this product automatically adapt to the frequencies set by
the system and do not require any parameter settings.
The TYPE field shows the correspondence between LYNX™ types and radio
modules:
TYPE: ABCDEE-FGH-IJJK-LMMMM
A: “0” if WWAN module is not present, “E” for GSM/GPRS/EDGE WWAN module, “U”
for HSDPA WWAN module, “H” for HSPA+ Voice and Data
B: “0” if GPS module is not present
C: “0” if IEEE 802.11 module is not present, “A” for IEEE 802.11 abg module, “G” for
IEEE 802.11 bg module, “N” for IEEE 802.11 bgn module
D: “0” if RFID module is not present.
BLUETOOTH® APPROVAL
For more information visit: http://www.bluetooth.org/tpg/listings.cfm.