Installation manual

v
GUIDE TO INSTALLATION
The following can be used as a checklist to verify all of the steps necessary for
complete installation of the DS4600A scanner.
1) Read all information in the section "Safety Precautions" at the beginning of this
manual.
2) Correctly position and mount the scanner for barcode reading according to the
information in paragraphs 2.2, 2.4 and 3.4.
3) Provide correct system cabling according to the signals necessary for your
application (see the applicable sub-paragraphs under 2.3).
4) Install the WinHost Configuration program from the CD.
Upon successful completion of the installation, the readme file is opened, giving
details about how to get started configuring your scanner.
See also the Guide to Rapid Configuration link in the Help On-Line.
Specific parameter details are also available in the Help On Line by pressing F1.
NOTE
Fine tuning of the scanner position for barcode reading can be
accomplished using the Test Mode as described in WinHost.
The installation is now complete.