Operation Manual

Mounting the Scanner
Integration Guide 11
Table 2. J2 Connector Pins
The following table outlines scan engine status assigned to each LED
(with recommended colors).
Pin Number Pin Functionality
1 LED1 Ctrl Signal, Trigger (active low)
2 LED2 Ctrl Signal, Status (open collector active low)
3 LED3, Power, (hard wired to VCC internally)
4 VCC_Out (5v for LED supply)
5Trigger Switch+
6 Trigger Switch- (ground)
POWER
(yellow)
ON = Power ON
OFF = Power OFF
STATUS
(green)
ON = Good Read
Blinks = USB enumeration or interface inactive or
waiting for change of configuration
TRIGGER
(blue)
ON = External trigger or button pressed or phase
active
Blinks = During transfer of captured image, or
during Flash memory updates
SWITCH Press for manual-controlled trigger