Operation Manual

Selecting the Interface Type
18 Gryphon™ I GBT4100
System and Network Layout
Typical Setup with Cradle and Host
Figure 7. Reader Layout
Selecting the Interface Type
Upon completing the physical connection between the reader and
its host, proceed directly to
Interface Selection on page 18 for in-
formation and programming for the interface type the reader is
connected to (for example: RS-232, Keyboard Wedge, USB, etc.)
and scan the appropriate barcode to select your system’s correct
interface type.
Interface Selection
Each reader model will support one of the following sets of host
interfaces:
General Purpose Models: RS-232, RS-232 OPOS, USB, Key-
board Wedge, Wand.
Retail Point of Sale Models : RS-232, RS-232 OPOS, USB, IBM
46XX.
Information and programming options for each interface type are
provided in this section.
Configuring the Interface
Scan the programming barcode which selects the appropriate in-
terface type matching the system the reader will be connected to.
If you need to customize additional settings and features associat-
ed with that interface, proceed to the corresponding chapter in
the Gryphon™ I PRG.