Instruction manual
Table Of Contents
- Table of Contents
- Gryphon™ D432/D412 Plus
- Warranty
- Patents
- LED Illuminator
- Aiming System

Default Configuration
Quick Reference Guide 15
DATA FORMAT – Concatenation
Concatenation disabled, 2 EAN/UPC codes concatenated, Set First Concatenated Code Length 000 =
any length, Set Second Concatenated Code Length 000 = any length, Set Third Concatenated Code
Length 000 = any length, Set Fourth Concatenated Code Length 000 = any length, Concatenation
with Intercode Delay disabled, Concatenation Timeout 10 seconds, Concatenation Failure Transmis-
sion = Tx codes causing failure, Transmission after Timeout = No code transmission, Concatenation
Result Code ID = No code Identifier
ADVANCED FORMATTING PARAMETERS
format disabled
POWER SAVE
Illumination power = ON
CODE SELECTION
issue identical codes = enable
enabled codes
Standard Code 39
: no check digit control, variable code length;
EAN 8/EAN 13 / UPC A/UPC E without ADD ON
: UPCE expansion disabled
Interleaved 2/5
: check digit control and transmission, variable code length
Code 128: variable code length
PDF417
Datamatrix: rectangular, normal and inverted, variable code length
QR
disabled codes
Code 32, Codabar, Code 93, EAN 128, RSS, Micro PDF417, Postal Codes, Maxicode, Composite Codes,
Aztec.
READING PARAMETERS
trigger type normal, trigger level mode, flash on = 2 sec, flash off = 2 sec, beeper tone = tone 1,
beeper volume = high, beeper duration = 50 ms, user defined beeper = tone 1, user defined
beeper volume = high, user defined beeper duration = 100 ms, code per scan = one code per scan,
read per cycle = one read per cycle, scan timeout = 5 sec, central code transmission enabled, order
by code length disabled, order by code symbology disabled, autoscan mode disabled, autoscan aim-
ing system enabled, autoscan hardware trigger enabled, autoscan illumination system disabled,
stand autoscan mode = normal, aiming system delay = disabled, good read spot = short, safety
time = 500 ms
IMAGE FORMATTING
Image Preset 1, 2, 3, 4
image format = JPEG, set JPEG quality factor = 50, brightness = 0%, contrast = 0%, zoom =
100%, color depth = 256 gray level.