Instruction manual

Default Configuration
14 Gryphon™ D432/412Plus
Default Configuration
RS232 Standard DEFAULT SETTINGS
115200 baud, no parity, 8 data bits, 1 stop bit, no handshake, no protocol,
FIFO enabled, intercharacter delay = 0, intercode delay = 0, serial trigger lock disabled, serial trig-
ger lock disable character = NUL, serial trigger lock enable character = NUL, RX Timeout = 10 sec
USB COM Emulation DEFAULT SETTINGS
no handshake, no protocol, FIFO enabled, intercharacter delay = 0,
intercode delay = 0
USB Keyboard Emulation DEFAULT SETTINGS
USA keyboard*, intercharacter delay = 0, intercode delay = 0, FIFO enabled,
keyboard speed = normal
WEDGE Communication DEFAULT SETTINGS
USA keyboard*, CapsLock OFF, CapsLock Auto-Recognition ON, NumLock OFF, intercharacter delay =
0, intercode delay = 0
IBM 46xx Interface DEFAULT SETTINGS
protocol= Port 5B 1520, format = IBM Standard Format
IBM USB Interface DEFAULT SETTINGS
device usage = handheld, format = IBM Standard Format
DATA FORMAT – Symbology Independent Parameters
Custom code identifier disabled, code identifier disabled, code length disabled
Default headers and terminators*:
- RS232: no header, terminator = CR-LF
- USB BULK: no header, terminator = CR-LF
- USB COM: no header, terminator = CR-LF
- USB Generic HID: no header, terminator = CR-LF
- Wedge: no header, terminator = ENTER
- USB Keyboard: no header, terminator = ENTER
- IBM 46xx: no header, no terminator
- IBM USB: no header, no terminator
DATA FORMAT – Symbology Dependent Parameters
symbology specific format = select all, no headers, no terminators, symbology character substitu-
tion disabled, symbology character deletion disabled
*The default values of these parameters are set when reading the interface
selection.