Instruction manual

USB Interface Configuration
Quick Reference Guide 9
Now you can read the USB interface configuration code according to
your application. Load drivers from the O.S. (if requested). When config-
uring the USB-COM interface, the relevant files and drivers must be
installed from the USB Device Installation software, which can be down-
loaded from the web site http://www.scanning.datalogic.com
.
The reader is ready.
Figure 1. First Start-Up
Successive start-ups will automatically recognize the previously loaded
drivers. If external power is used, verify that external power is already sup-
plied.
Figure 2. Successive Start-Ups
Does a dialog
box appear
warning that Bus
power is not
su f fic ie n t?
G reen LED off
Selec t d esire d US B
in t e rfa ce co de
(US B-K BD is d efault)
NO
YE S
Read test codes.
Reader is READY
Load drivers
(if reque sted )
Load drivers
(if reque sted )
Green L ED blinks
Green L ED off - BEEP OK
BEEP OK
Connect
Gryphon™ D432/D412 + to Host
Disconnect reader
at H o st
Connect external
power supply to
cable and power up
Reconnect reader
cable to Host and
close dialog box
NO
YE S
Read test codes.
Reader is READY
G reen LED blinks
Green L ED off - BEEP OK
BEEP O K
Connect Gryphon™ D432/D412 +
to H o s t
Disconnect reader at Host
Connect external power supply to
cable and
p
ower u
p
Reconnect reader cable to
Host and close dialog box
Does a dialog box
appear warning
that Bus power is
no t su ffi cie n t?