User Manual

Enter/Exit Programming Mode
46 Gryphon™ I GD44XX/GBT4400/GM440X
ACK Character
This setting specifies an ASCII character or hex value to be used as the ACK
character. ASCII characters or any hex value from 0 to 0xFF can be selected.
See page 274 for more information.
$CR2AC
Select ACK Character Setting
Setting to previously defined characters such as XON, XOFF, or host commands conflicts with
normal operation of these characters. 8-bit data is not recognized when the option
Data Bits
has been set as 7 Data Bits.
NAK Character
This setting specifies an ASCII character or hex value to be used as the NAK
character. ASCII characters or any hex value from 0 to 0xFF can be selected.
Setting to previously defined characters such as XON, XOFF, or host commands conflicts with
normal operation of these characters. 8-bit data is not recognized when the option
Data Bits
has been set as 7 Data Bits.
See page 275 for more information.
$CR2NA
Select NAK Character Setting
DEFAULT
0x06 ‘ACK’ Character
DEFAULT
0x15 ‘NAK’ Character