User Manual

Setup

Gryphon™ I GD44XX/GBT4400/GM440X

Interface Selection

Upon completing the physical connection between the reader and its host,

proceed to Table 1

starting on page 23 to select the interface type the reader

is connected to (for example: RS-232, Keyboard Wedge, USB, etc.). Scan the

appropriate bar code in that section to configure your system’s correct

interface type.

Each reader model will support one of the following sets of host interfaces:

Setting the Interface

Scan the programming bar code from this section which selects the appro-

priate interface type matching the system the reader will be connected to.

Next, proceed to the corresponding section in this manual (also listed in

Table 1 on page 23) to configure any desired settings and features associ-

ated with that interface.

General Purpose Models Retail Point of Sale Models

•RS-232

• RS-232 OPOS

•USB-COM

• Keyboard Wedge

• Wand Emulation (BT only)

•RS-232

• RS-232 OPOS

• USB

•IBM 46XX

Unlike some programming features and options, interface selec-

tions require that you scan only one programming bar code label.

DO NOT scan an ENTER/EXIT bar code prior to scanning an interface

selection bar code.

Some interfaces require the scanner to start in the disabled state

when powered up. If additional scanner configuration is desired

while in this state, pull the trigger and hold it for five seconds. The

scanner will change to a state that allows programming with bar

codes.