User Manual

LED and Beeper Indications
Product Reference Guide 309
Table 4
Programming Mode - The following indications ONLY occur when the reader is in Programming Mode.
Label Program-
ming Mode
Entry
A valid programming label
has been scanned.
LED blinks continuously
Reader sounds four low fre-
quency beeps.
Label Program-
ming Mode
Re
jection of
Label
A label has been rejected. N/A
Reader sounds three times
at lowe
st frequency & cur-
rent volume.
Label Program-
ming Mode
Acceptance of
Partial Label
In cases where multiple
l
abels must be scanned to
program one feature, this
indication acknowledges
each portion as it is success-
fully scanned.
N/A
Reader sounds one short
beep at
highest frequency &
current volume.
Label Program-
ming Mode
Acceptance of
Program
ming
Configuration option(s) have
be
en successfully pro-
grammed via labels and the
re
ader has exited Program-
ming Mode.
N/A
Reader sounds one high fre-
quency beep and 4 low fre-
quency beeps followed by
r
eset beeps.
Label Program-
ming Mode
Cancel
Item
Entry
Cancel label has been
scanned.
N/A
Reader sounds two times at
l
ow frequency and current
volume.
. Programming Mode Indications