User Manual

Positioning the Base Station

Product Reference Guide

Linking the Reader to a Base Station

RF Devices

For RF devices, before configuring the interface it is necessary to link the

handheld with the base. To link the handheld and the base, press the trigger

to wake it and place it on the base. If the reader was previously linked to

another base, you must first scan the Unlink action command before re-

linking to the new base.

Unlink

BT Models only

Remember: The mandatory condition for establishing a new linking between

a BT handheld and a BT base is that the handheld is unlinked and they share

the same security configuration. A successful link is indicated by three

ascending tones from the reader. A high-low-high-low tone indicates the

link attempt was unsuccessful. A single green LED flash after this tone indi-

cates no Base Station was discovered. Two green LED flashes after this tone

indicate

s that more than one Base Station was discovered and the reader did

not link. Three LED flashes after this tone indicate a security error.