User Manual

Setup
16 Gryphon™ I GD44XX/GBT4400/GM440X
Figure 10. Connecting to the Host
U
S
B
I
B
M
K
e
y
b
o
a
r
d
W
e
d
g
e
W
a
n
d
or...
or...
or...
Power Connection : Plug the AC Adapter in to an approved AC wall socket with
the cable facing downwards (as shown in Figure 7) to prevent undue strain
on the socket.
Disconnecting the Cable: To detach the cable, insert a paper clip or similar
object into the hole on the base, as shown in Figure 11.
Figure 11. Disconnecting the Cable
Insert
Paper Clip
Connecting the Base when Security Pin is Enabled
When connecting the Base to a system that has a custom Security Pin
enabled, follow the steps below in the order shown:
1. Power down the host system.
2. Connect the appropriate interface cable into the Base as sh
own in Fig-
ure 10.
3. Place the reader in the Base.
4. Power up the host. The reader will link to the Base
5. When the host completely powers up,
a new custom Security Pin Code
may be sent to the reader and Base, depending on host configuration.
Contact Datalogic Technical Support for more information.
If you want to change security settings or set up a PIN, see "BT
Security Mode" starting on page 253.