User Manual

Enter/Exit Programming Mode PDF417
224 Gryphon™ I GD44XX/GBT4400/GM440X
PDF417 Set Length 2
This feature specifies one of the bar code lengths for PDF417 Length Con-
trol. Length 2 is the maximum label length if in Variable Length Mode, or the
second fixed length if in Fixed Length
Mode. Length includes the bar code’s
check, data, and full-ASCII shift characters. The length does not include
start/stop characters. Characters can be set from 01 to 2,710 characters
(pad with zeroes) in increments of 01. Any value greater than 2,710 will be
considered to be 2,710.
See page 283 for detailed instructions on setting this feature.
$CP4L2
Select PDF417 Length 2 Setting
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start again
at the beginning.
CANCEL
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code
at left followed by the digits from the Alphanumeric
characters in
Appendix D, Keypad representing
your desired character(s). End by scanning the
ENTER/EXIT bar code again.
~
DEFAULT
Length 2 is 2,710 Characters