User Manual

Enter/Exit Programming Mode Maxicode
220 Gryphon™ I GD44XX/GBT4400/GM440X
Maxicode Length Control
This feature specifies either variable length decoding or fixed length decod-
ing for this symbology.
Variable Length: For variable length decoding, a minimum and maximum
length may be set.
Fixed Length: For fixed length decoding, two different lengths may be set.
$CMXLC00(CR)
Maxicode Length Control = Variable Length
$CMXLC01(CR)
Maxicode Length Control = Fixed Length
Maxicode Set Length 1
Specifies one of the bar code lengths for Maxicode Length Control. Length 1
is the minimum label length if in Variable Length Mode, or the first fixed
length if in Fixed L
ength Mode. Characters can be set from 0001 to 0145
characters in increments of 0001 (pad with zeroes).
See page 283 for detailed instructions on setting this feature.
$CMXL1
Select Maxicode Length 1 Setting
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start again
at the beginning.
CANCEL
DEFAULT
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code
at left followed by the digits from the Alphanumeric
characters in
Appendix D, Keypad representing
your desired character(s). End by scanning the
ENTER/EXIT bar code again.
~
DEFAULT
0001 = Length 1 is 1 Character