User Manual

Product Reference Guide

Chapter 2

Setup

Unpacking

Check carefully to ensure the reader and any accessories ordered are pres-

ent and undamaged. If any damage occurred during shipment, contact Dat-

alogic Technical Support. Information is shown on page 2.

KEEP THE PACKAGING. Should the unit ever require service, it should be

turned in its original shipping container.

Setting Up the Reader

Depending on whether you are using a Corded or BT version of the Gryphon,

follow the steps provided in this section to connect and get your reader up

d communicating with its host.

1. Begin by Installing the Interface Cable (Corded) or Connecting the Base

Station (BT)

2. Go to Interface Selection and set the desired interface.

3. Configure Interface Settings (only if not using factory settings for that

interface)

4. Go to Configuring Other Features (if modifications are needed from

factory settings)

According to recent modification of Regulation for shipping Li-Ion based

battery packs, the products and their spare battery packs parts are shipped

with a very low residual charge (low state of charge).

Hence the needs:

* that a new product must be fully recharged before starting to use it

and

* that battery packs of the stocked products G

BT/GM44 and spare battery

pack parts must be periodically recharged : for instance by using a BC40xx

cradle powered up with a 12V Datalogic AC/DC adapter (cod. 8-0935) for at

least 30 minutes each 3 months.