Operation Manual

Product Reference Guide 93
SYMBOLOGIES
1D Code Selection
The reader supports the following 1D symbologies (bar code types). See "2D Symbologies"
starting on page 185
for 2D bar codes. Symbology-dependent options are included in each
chapter.
• Disable All Symbologies on page 94 • GS1-128 on page 132
• Code EAN/UPC on page 95 • Code ISBT 128 on page 133
• UPC-E on page 98 • Interleaved 2 of 5 (I 2 of 5) on page 136
• GTIN Formatting on page 101 • Interleaved 2 of 5 CIP HR on page 141
• EAN 13 (Jan 13) on page 102 • "Follett 2 of 5" on page 141
• ISSN on page 104 • Standard 2 of 5 on page 142
• EAN 8 (Jan 8) on page 105 • Industrial 2 of 5 on page 146
• UPC/EAN Global Settings on page 107 • Code IATA on page 150
• Add-Ons on page 109 • Codabar on page 151
• Code 39 on page 116 • ABC Codabar on page 157
• Trioptic Code on page 122 • Code 11 on page 160
• Code 32 (Ital Pharmaceutical Code) on page 122 • GS1 DataBar™ Omnidirectional on
page 164
• Code 39 CIP (French Pharmaceutical) on
page 124
• GS1 DataBar™ Expanded on page 165
• Code 39 Danish PPT on page 124 • GS1 DataBar™ Limited on page 170
• Code 39 LaPoste on page 125 • Code 93 on page 171
• Code 39 PZN on page
125 • MSI on page 176
• Code 128 on page 126 • Plessey on page 181
Default settings are indicated at each feature/option w
ith a green arrow. Also reference
Appendix C, Standard Defaults for a listing of the most widely used set of standard factory
settings. That section also provides spac
e to record any custom settings needed or implemented
for your system.
To set most features:
1. Scan the ENTER/EXIT PROGRAMMING bar code at the top of applicable pr
ogram-
ming pages.
2. Scan the correct bar code to set the desired programming feature or parameter. You may
need to cove
r unused bar codes on the page, and possibly the facing page, to ensure that
the reader reads only the bar code you intend to scan.
3. If additional input parameters are needed, go to Appendix E, Keypad, and scan the appro-
priate characters from the keypad.
Additional information about many features can be found in the “References”
chapter.
If you make a mistake before the last character, scan the CANCEL bar code to abort
and not
sav
e the entry string. You can then start again at the beginning.
4. Complete the programming sequence by scanning the ENTER/EXIT PROGRAM-
MING bar code to exit Programming Mode.