Operation Manual

Enter/Exit Programming Mode Reading Parameters

Gryphon™ I GFS4400

Central Code Only

Specifies the ability of the reader to decode labels only when they are close to the center of the

aiming pattern. This allows the reader to accurately target labels when they are placed close

together, such as on a pick sheet.

See Appendix B, Aimer Calibration starting on page 287 for information about setting the

aiming coordinates.

This feature is not compatible with Multiple Labels Reading in a Volume.

DEFAULT

$CSNPM00(CR)

Central Code Only = Disable

$CSNPM01(CR)

Central Code Only = Enable

Illumination Off Time

This feature defines the amount of time illumination is kept OFF after Illumination ON

timeout. When illumination OFF expires, Object Sense is resumed. This configuration is

available in Automatic (Object Sense) only. Range is 0 millisecond to 25.5 milliseconds in 100

millisecond intervals.

$CSNOO

Select Presentation Mode Time Setting

To configure this feature, scan the ENTER/EXIT PROGRAM-

MING MODE bar code above, then the bar code at left fol-

lowed by the digits from the Alphanumeric characters in

Appendix E, Keypad representing your desired charac-

ter(s). End by scanning the ENTER/EXIT bar code again.

DEFAULT

0 milliseconds