Operation Manual

Reading Parameters Enter/Exit Programming Mode

Product Reference Guide

Phase Off Event

$CSPTO00\r

Trigger Stop

DEFAULT

$CSPTO01\r

Timeout

$CSPTO02\r

Trigger Stop - Timeout

Phase Off Timeout

Timeout can be set within a range of 1second to 255 seconds in 1 second intervals.

$CSNET

Scanning Active Time

To configure this feature scan the ENTER/EXIT PROGRAMMING

MODE barcode above, then the barcode at left, followed by

the digits (in hex) from the Alphanumeric characters in

Appendix E, Keypad

representing your desired charac-

ter(s). End by scanning the ENTER/

EXIT barcode again.

Make a mistake? Scan the CANCEL barcode to abort and not

save the en

try string. You can then start again at the begin-

ning.

CANCEL

DEFAULT

5 = Timeout set for 5 seconds