Operation Manual

Reading Parameters Enter/Exit Programming Mode

Product Reference Guide

Good Read LED Duration

This feature specifies the amount of time that the Good Read LED remains on following a good

read. The good read LED on time can be set within a range of 100 milliseconds to 25,500

milliseconds (0.1 to 25.5 seconds) in 100ms increments. A setting of 00 keeps the LED on until

the next trigger push.

See page 269 in “References” for detailed instructions and examples for setting this feature.

$CLAGL00(CR)

Good Read LED Duration Setting =

Keep LED on until next trigger push

$CLAGL

Select Good Read LED Duration Setting

To configure this feature, scan the ENTER/EXIT PROGRAM-

MING MODE bar code above, then the bar code at left fol-

lowed by the digits from the Alphanumeric characters in

Appendix E, Keypad representing your desired charac-

ter(s). End by scanning the ENTER/EXIT bar code again.

Make a mistake? Scan the CANCEL bar code to

abort and

not save the entry string. You can then start again at the

beginning.

CANCEL

DEFAULT

003 = Good Read LED

stays on for 300 ms.