Operation Manual

Data Format Enter/Exit Programming Mode
Product Reference Guide 65
Match String
This feature allows you to define the string to be used as the match code for Code Verification.
The Match String must be configured to include start/stop characters and check digits if their
transmission is enabled. See "Match String" on page 265 in References for more information.
It is possible to define the Match string by inserting:
• a
ll printable characters
• non printable ASCII characters
No wild card characters are supported.
$CCOVS
Set Match String
To configure this feature, scan the EN
TER/EXIT PROGRAMMING
MODE barcode above, then the barcode at left followed by the
digits (in hex) from the Alphanumeric characters in
Appendix
E Keypad
representing your desired character(s). End by
scanning the ENTER/EXIT barcode again.
Make a mistake? Scan the CANCEL barcode to abort and not
sav
e the entry string. You can then start again at the beginning.
~
CANCEL
Wrong Code String
$CWCVS
Set Wrong Code String
To configure this feature, scan the ENTER/EXIT PROGRAMMING
MODE barcode above, then the barcode at left followed by the
digits (in hex) from the Alphanumeric characters in
Appendix
E Keypad
representing your desired character(s). End by
scanning the ENTER/EXIT barcode again.
Make a mistake? Scan the CANCEL barcode to abort and not
sav
e the entry string. You can then start again at the beginning.
~
CANCEL
See "Wrong Code String" on page 266 in References for more information about this feature.