Operation Manual

RS-232/USB-Com Interfaces Enter/Exit Programming Mode

Product Reference Guide

Intercharacter Delay

This parameter specifies the intercharacter delay between the end of one character and the

beginning of the next. The delay can be set within a range of zero (0) to 990 milliseconds in

10ms increments. A setting of zero specifies no delay.

$CR2IC00(CR)

Intercharacter Delay = No Delay

$CR2IC

Select Intercharacter Delay Setting

To configure this feature, scan the ENTER/EXIT

PROGRAMMING MODE bar code above, then the

bar code at left followed by the digits from the

Alphanumeric characters in Appendix E, Keypad

representing your desired character(s). End by

scanning the ENTER/EXIT b

ar code again.

Make a mistake? Scan the CANCEL bar code to abort

and not save the entry string. You can then start again at

the beginning.

CANCEL

DEFAULT

00 = No Intercharacter Delay

Beep On ASCII BEL

When this parameter is enabled, the reader issues a beep when a <BEL> character is detected on

the RS-232 serial line. <BEL> is issued to gain a user's attention to an illegal entry or other

important event.

$CR2BB00(CR)

Beep On ASCII BEL = Disable

DEFAULT

$CR2BB01(CR)

Beep On ASCII BEL = Enable