Operation Manual

Technical Specifications
Product Reference Guide 285
Programming Mode - The following indications ONLY occur when the reader is in Programming
Mode
.
Indicator Description LED Beeper
Label Programming
Mode Entry
A valid programming label
has been scanned.
LED blinks continu-
ously
Reader sounds four
low frequency beeps.
Label Programming
Mode Rejection of
Lab
el
A label has been rejected. N/A
Reader sounds three
time
s at lowest fre-
quency and current
volume
.
Label Programming
Mode Accep
tance of
Partial Label
In cases where multiple
labels m
ust be scanned t
o
program one feature, this
indication acknowledges
each portion as it is suc-
cessfully scanned.
N/A
Reader sounds one
shor
t beep at highest
fr
equency and cur-
rent volume.
Label Programming
Mode Accep
tance of
Programming
Configuration option(s)
have be
en successfully pro-
grammed via labels and the
r
ead
er has exited Program-
ming Mode.
N/A
Reader sounds one
high fre
quency beep
and 4 low frequency
beeps followed by
reset beeps.
Label Programming
Mode C
anc
el Item
Entry
Cancel label has been
scanned
.
N/A
Reader sounds two
ti
mes at
low fre-
quency and current
vol
ume
.
Error Codes
Upon startup, if the reader sounds a long tone, this means the reader has not passed its automatic
Selftest and has entered FRU (Field Replaceable Unit) isolation mode. If the reader is reset, the
sequence will be repeated. Press and release the trigger to hear the FRU indication code.
The following table describes the LED flashes/beep codes associated with an error
found.
Number of LED Flashes/
Beeps
Error Corrective Action
1 Configuration
Contact Helpdesk
for assi
stance
2 Interface PCB
6 Digital PCB
11 Imager