Operation Manual

References Data Editing
266 Gryphon™ I GFS4400
No wild card characters are supported.
To set this feature:
1. Determine the desired character string (max 32).
2. Reference the ASCII Chart on the inside back cover of this manual to find the hex value
assigned to t
he desired character.
3. Go to "
Match String" on page 65 and scan ENTER/EXIT PROGRAMMING MODE to
enter Programming Mode.
4. Scan the barcode: SELECT MATCH STRING.
5. Turn to
Appendix E, Keypad and scan the barcodes representing the hex characters deter-
mined in step 1 above.
6. If less than the expected string of 32 characters are selected,
scan the ENTER/EXIT bar-
code to terminate the string.
7. Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit Programming
Mod
e.
This completes the procedure.
Wrong Code String
The string sent in case of a mismatch (wrong code read).
To set this feature:
1. Determine the desired character string (max 20).
2. Reference the ASCII Chart on the inside back cover of this manual to find the hex value
assigned to t
he desired character.
3. Go to "
Wrong Code String" on page 65 and scan ENTER/EXIT PROGRAMMING MODE
to enter Programming Mode.
4. Scan the barcode: SELECT WRONG CODE STRING.
5. Turn to
Appendix E, Keypad and scan the barcodes representing the hex characters deter-
mined in step 1 above.
6. If less than the expected string of 20 characters are selected,
scan the ENTER/EXIT bar-
code to terminate the string.
7. Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit Programming
Mod
e.
This completes the procedure.
Label Transmit Mode
Specifies whether the decoded label must be transmitted over the host interface as it has been
decoded or after the reading phase has been deactivated (phase off). This does not apply to Test
Mode.