Operation Manual

Data Editing References
Product Reference Guide 263
Table 34
STEP ACTION EXAMPLES
1. Scan the ENTER/EXIT bar code
(Scanner enters Programming Mode)
2.
Determine placement of the
Label ID charac
ters BEFORE or
AFTER with regard to scanned
data using
Label ID
Control, starting on page 57
Enable as Prefix Enable as Suffix Enable as Prefix Enable as Suffix
3.
Scan the bar code selecting
the symbology type y
ou wish
to designate label ID
characters for using
Label ID
Symbology Selection − 1D
Symbologies, starting on page 58
.
DataBar
Omnidirectional
Code 39 Interleaved 2 of 5 Code 32
4.
Custom Label ID example
(desired characters):
D B * = C 3 + P H
5.
Find hex equivalents from the
ASCII Chart (inside back cover),
then scan in these digits/
charact
ers using the bar codes
in the section:
Keypad, starting
on page 307
. If you make a
mistake before the last
character, scan the CANCEL
bar code to abort and not save
the entry string. You can then
start again at the beginning.
44 42 2A 3D 43 33 2B 50 48
6. Scan the ENTER/EXIT bar code
(Scanner exits Label ID entry)
7.
Scan the ENTER/EXIT bar code
once again
(Scanner exits Programming Mode)
Result:
DB*[bar code
data]
[bar code
data]=C3
+[bar code data] [bar code data]PH
. Label ID Examples