Operation Manual

You must first enable your reader to read bar codes in order to use this
section. If you have not done this, go to
Setup, starting on page 13 and
complete the appropriate procedure.
Enter/Exit Programming Mode
22 Gryphon™ I GFS4400
To program features:
1. Scan the ENTER/EXIT PROGRAMMING bar code, available at the top of each pro-
gramming page, when applicable.
2. Scan the bar code to set the desired programming feature. You may need to cover unused
bar codes on the page, and possibly the facing page,
to ensure that the reader reads only
the bar code you intend to scan.
3. If additional input parameters are needed, go to Appendix E, Keypad, and scan the appro-
priate characters from the keypad.
Additional information about many features can be found in the “Refer-
ences” chapter.
If you make a mistake before the last character, scan the CANCEL bar code
to
ab
ort and not save the entry string. You can then start again at the
beginning.
4. Complete the programming sequence by scanning the ENTER/EXIT PROGRAM-
MING bar code to exit Programming Mode.
For more detailed descriptions, programming information and examples
for setting selected
configuration items,
see References, starting on page 245.