Operation Manual

INTERFACE SELECTION COMMANDS
Description Command
Restore Current Interface (Custom) Default Configuration HA00
RS232-STD HA05
USB-COM HA47
RS232-Wincor-Nixdorf HA12
USB-KBD HA35
USB-KBD-ALT HA2B
USB KBD-APPLE HA2C
RS-232 ONLY PARAMETERS
Description Parameter Value
Baud Rate 1200 R2BA 00
2400 01
4800 02
9600 03
19200 04
38400 05
57600 06
115200 07
Parity none R2PA 00
even 01
odd 02
Data Bits 7 R2DA 00
8 01
Stop Bits 1 R2ST 00
2 01
Handshaking Control RTS R2HC 00
RTS/CTS R2HC 01
RTS/Xon/Xoff R2HC 02
RTS On/CTS R2HC 03
RTS/CTS Scan Control R2HC 04
To read a particular parameter setting from the reader, send the
read parameter command without any value. The reader will
respond with its currently configured value.
The Read Application Software Release command is a direct com-
mand that does not require entering Service Mode.
Software Configuration Strings
Product Reference Guide 221