User manual
Table Of Contents
- CONTENTS
- GENERAL VIEW
- INTRODUCTION
- INSTALLATION
- GRYPHON™ MX30 SYSTEM AND NETWORK LAYOUTS
- CONFIGURATION
- RS232 PARAMETERS
- USB PARAMETERS
- WEDGE PARAMETERS
- PEN EMULATION
- DATA FORMAT
- POWER SAVE
- READING PARAMETERS
- DECODING PARAMETERS
- CODE SELECTION
- ADVANCED FORMATTING
- RADIO PARAMETERS
- REFERENCES
- TECHNICAL FEATURES
- A HOST CONFIGURATION STRINGS
- B CODE IDENTIFIER TABLE
- C HEX AND NUMERIC TABLE

CONTENTS
GENERAL VIEW ....................................................................................... viii
1 INTRODUCTION .......................................................................................... 1
2 INSTALLATION............................................................................................ 2
2.1 Gryphon™ Dx30 Interface Cable Connections ............................................. 2
2.2 OM-Gryphon™ Interface Cable Connections................................................ 3
2.3 RS232 Connection........................................................................................ 4
2.4 USB .............................................................................................................. 4
2.5 IBM USB POS............................................................................................... 5
2.6 WEDGE Connection ..................................................................................... 5
2.7 PEN Emulation Connection........................................................................... 7
2.8 Gryphon™ Mx30 Battery Maintenance ......................................................... 8
2.8.1 Battery Type.................................................................................................. 8
2.8.2 Battery Charging ........................................................................................... 8
2.8.3 Replacing Gryphon™ M Batteries................................................................. 9
3 GRYPHON™ MX30 SYSTEM AND NETWORK LAYOUTS ........................ 11
3.1 Stand Alone Layouts................................................................................... 11
3.1.1 Single Reader Layout.................................................................................. 11
3.1.2 Multiple Reader Layout ............................................................................... 11
3.1.3 Multiple Stand Alone Layouts...................................................................... 12
3.2 Multidrop STAR-System™ Network Layouts............................................... 13
3.2.1 Host Master Layout..................................................................................... 13
4 CONFIGURATION...................................................................................... 14
4.1 Configuration Methods................................................................................ 14
4.1.1 Reading Configuration Barcodes ................................................................ 14
4.1.2 Using DL Sm@rtSet.................................................................................... 14
4.1.3 Copy Command .......................................................................................... 14
4.1.4 Sending Configuration Strings from Host .................................................... 15
4.2 Setup Procedures ....................................................................................... 15
4.3 Gryphon™ Dx30 Setup............................................................................... 16
4.4 Gryphon™ Mx30/OM-Gryphon™ Stand Alone Setup................................. 16
4.4.1 Using Multiple M-Series Readers With Same Cradle.................................. 18
4.4.2 Gryphon™ M/STAR-Modem™ in Stand Alone Mode ................................. 19
4.5 Gryphon™ M/STAR-System™ Setup ......................................................... 20
4.6 Interface Selection ...................................................................................... 22
4.7 USB Reader Configuration.......................................................................... 27
4.8 Changing Default Settings .......................................................................... 30
iii










