User manual
Table Of Contents
- CONTENTS
- GENERAL VIEW
- INTRODUCTION
- INSTALLATION
- GRYPHON™ MX30 SYSTEM AND NETWORK LAYOUTS
- CONFIGURATION
- RS232 PARAMETERS
- USB PARAMETERS
- WEDGE PARAMETERS
- PEN EMULATION
- DATA FORMAT
- POWER SAVE
- READING PARAMETERS
- DECODING PARAMETERS
- CODE SELECTION
- ADVANCED FORMATTING
- RADIO PARAMETERS
- REFERENCES
- TECHNICAL FEATURES
- A HOST CONFIGURATION STRINGS
- B CODE IDENTIFIER TABLE
- C HEX AND NUMERIC TABLE
GRYPHON™ Dx30/Mx30
4
Connect Gryphon™
Dx30 to Host
Does a dialog box
appear warning that
Bus power is not
sufficient?
Select desired USB
interface code
(USB-KBD is default)
Discon
at
nect reader
Host
Connect external
power supply to
cable and power up
Recon
cable
close dialog box
NO
nect reader
to Host and
YES
Read test codes.
Reader is READY
Load drivers
f requested) (i
Load drivers
(
if re
q
uested
)
Green LED blinks
Green LED off - BEEP OK
BEEP OK
First UpStart-
Green LED off
Successive start-ups will autom he previously loaded drivers. If
external power is used, verif pplied.
atically recognize t
y that external power is already su
NO
YES
Read test codes.
Reader is READY
Green LED blinks
Green LED off - BEEP OK
BEEP OK
Connect Grypho
Dx30 to H
n™
ost
Success e Start-Upsiv
Disconnect reader
at Host
Connect external
power supply to
cable and power up
Reconnect reader
cable to Host and
close dialog box
Does a dialog box
appear warning that
Bus power is not
sufficient?
28